Reduce Creaking in Tall Buildings

Reduce Creaking in Tall Buildings

Tall buildings, much like tall trees, sway in windy conditions. This is caused by a phenomenon known as vortex shedding.
Key Points:
  • Buildings sway in windy conditions and when buildings sway, they creak.
  • Studco® has led an in-depth 2 year research project analyzing global wind studies and performed field investigations within buildings with known noise problems.
  • Studco’s engineers have designed the Vortex High Performance Framing System® specifically to address the causes of creaking in tall buildings.
Read time: 2 mins

Vortex shedding occurs when wind runs into a tall building and the wind is “split” into two separate air streams around the building. This generates areas of low pressure on the opposite side of the building, which creates a suction-effect that causes the building to sway. And when that building sways, it creaks. Some buildings can generate creaking sounds up to 70 decibels (dB). This is louder than a conversation in a restaurant or office, and can be as loud as a running vacuum cleaner. This keeps apartment residents awake at night, and terrifies unsuspecting hotel guests.

Creaking has been a problem in tall buildings for a long time, but the specific causes of the creaking were unknown. So, Studco led an in-depth two-year research project that analyzed global wind studies and performed field investigations within buildings that had known noise problems. This led to the discovery that the head track in the steel stud wall system was not fit for purpose when fixing to an uneven surface: the head track becomes deformed as it follows the contours of the substrates uneven surface, putting tension on the profile as a result of elastic buckling, and in some extreme cases, plastic deformation occurs when the track becomes creased and permanently damaged. As the building vibrates and sways in a cyclical pattern with the wind, the tension in the track causes an irritating creaking noise.

Studco’s engineers designed the Vortex High Performance Framing System specifically to address the variable surfaces of modern concrete structure and the stresses and tension that tall buildings experience in high winds. This lightweight steel framing system reduces stress and tension from the
building’s internal framing by using features such as rigid beams which increases stiffness and resists buckling, anti-tension kerfs which limits deformation where the substrate is extremely uneven, and isolation clips to reduce metal-on-metal contact with wall studs, door jambs and ceiling wall track sections. These are just a few of the features that significantly reduce the creaking sound in tall buildings, and lead to positive experiences for the residents and guests within them.

Vortex Framing System installation - Studco AU
Our apartment creaked a lot before. We replaced the walls with the Vortex system from Studco and the problem has disappeared.
S. Volker, Melbourne, Australia

Studco continues to monitor the performance of the Vortex High Performance Framing System and makes improvements based on the data we gather.

If you are an Architect or Builder and would like to speak to our Product Specialist about using the Vortex System in your project, call us on 1300 255 255, or complete our online contact form today.

Case Studies

Light House Tower, VIC
Products Used
Vortex Isolation Clips, Steel Stud and Track, EZ Concept Architectural Finishing Systems


News letter in footer section

"(Required)" indicates required fields

This field is for validation purposes and should be left unchanged.